After your part is disassembled, we thoroughly clean the part removing all dirt, oil, grease, and grime in order to have a clean application of the powder coating. After cleaning the part is ready for Pre-Baking. This process heats up the oils inside of the part and drives them out in a 440F oven for 40-120 minutes.
Masking is a tedious but required part of powder coating. Masking is also dependent on the part and it is the very last step before the part is powder coated. All parts are grounded and powder is applied in a dust-free and clean environment with proper airflow during coating. Compressed air at +38 degrees and contains less than 0.1-PPM oil with no particulate contaminants greater than 0.3 microns.
Masking is a tedious but required part of powder coating. Masking is also dependent on the part and it is the very last step before the part is powder coated. All parts are grounded and powder is applied in a dust-free and clean environment with proper airflow during coating. Compressed air at +38 degrees and contains less than 0.1-PPM oil with no particulate contaminants greater than 0.3 microns.
Services
About Us
Report
Our facility is UL approved for clear coating applications over polished brass, copper, stainless steel, and other powder coated surfaces. This procedure meets the ANSI/NSF standard number 51 for Food Service Equipment Component materials for use in steam condensate and non-food contact areas. We can handle any and all size type of jobs.
Reviews
Be the first to review Powder Coating Plus.
Write a Review
